FiltersDone

Question type

Essay

Multiple Choice

Short Answer

True False

Matching

Exam 18: Transmission Reassembly

Show Answer

Share

---

All types

Filters

Study FlashcardsPractice ExamLearn

Question 31

Multiple Choice

Review LaterAdd Note

Review Later

Technician A says you should coat lip seals with transmission assembly lube. Technician B says you can use petroleum jelly to lubricate lip seals. Who is correct?

A) Technician A
B) Technician B
C) Both A and B
D) Neither A nor B

E) A) and D)
F) B) and C)

Correct Answer

verified

Show Answer

Question 32

Multiple Choice

Review LaterAdd Note

Review Later

When installing valve body bolts:

A) look up torque specifications and torque sequences.
B) use a small air ratchet.
C) use an impact gun.
D) the bolts need not be location specific.

E) None of the above
F) C) and D)

Correct Answer

verified

Show Answer

Question 33

Multiple Choice

Review LaterAdd Note

Tech A says that it is fine to tighten bolts on a transmission using an air ratchet if you set the torque level low on the air ratchet. Tech B states that a torque wrench should always be used when torqueing bolts. Who is correct?

Technician A says you should coat lip seals with transmission assembly lube. Technician B says you can use petroleum jelly to lubricate lip seals. Who is correct?

Technician A says that painting a rebuilt transmission helps to identify it as being a rebuilt transmission. Technician B says that painting a rebuilt transmission prevents the housing from leaking due to case porosity. Who is correct?

What problems may occur if you fail to torque parts correctly when reassembling an automatic transmission?

Tech A says that it is fine to tighten bolts on a transmission using an air ratchet if you set the torque level low on the air ratchet. Tech B states that a torque wrench should always be used when torqueing bolts. Who is correct?

Which of the following tools is used after the new input shaft seals are installed and before the reverse input drum is ready to be installed?

What are the best tools to install a new transmission seal in the extension housing?

All of the following statements are true with respect to final transmission assembly except:

What purpose does painting a rebuilt transmission serve?

Techncian A says preload refers to the amount of force placed on a bearing before any working load is exerted on the bearing. Technician B says free play refers to the amount that a bearing is able to move before hitting the bearing race. Who is correct?

Tech A states that an end play measurement that is too small can mean that you have excessive clearance in the clutch packs. Tech B states that an end play measurement that is too large means that the thrust washers are too big. Who is correct?

Technician A says preload refers to the amount of force placed on a bearing before any load is on the bearing. Technician B says free play refers to the distance that a bearing is able to turn before locking up. Who is correct?

All of the following statements are true with respect to end play except:

Tech A states that on some transmissions it might be necessary to place components in a freezer to allow them to contract slightly. Tech B states that on some transmissions it might be necessary to place components in hot water to allow them to expand slightly. Who is correct?

On a rear-wheel drive vehicle, what needs to be removed to replace the extension housing bushing?

Which of the following terms refers to the amount of force placed on a bearing before any vehicle load is on the bearing?

The technician should always use a bushing driver to install new bushings into an automatic transmission.

Which of the following bushings is most likely to be worn and need replacement during a transmission repair or overhaul?